TH400 with 4-1/2 inch output to Fig 8 NP205 Adapting Kit

Everything you need to adapt a Figure 8 NP205 to a TH400 with a 4.5" output shaft stick out length

Some things on this list you may or may not need but it is easy to remove them.

The First item is the adapter. This is needed to connect the transmission to the NP205

If you dont have a 32 spline female input for your NP205 we have one listed on this page. If your transfer case origninally came with a 10, 27, or 23 spline input shaft you will need to have the case bored to accept the larger input. We do offer that service if needed. Labor to machine case

Finally are the twin stick shifters. These are a great route if you need a shifter, you can do rear wheel drive low with them! All that is needed to know is if you have long rail or short rail. Info on that can be found here:  Twin Stick Info

Below is how to measure your output shaft length: